ONKYO TX-NR900 Instruction Manual
69
Using remote controller
SAT/MD MODE
ON
STANDBY
VOL
MUTING
ENTER
MD
operation
buttons
operation
buttons
Numeric keys
Controlling an Onkyo MD recorder
The
connector of the Onkyo MD recorder must be connected to
the TX-NR900/900E (see page 28).
1. Press the SAT/MD MODE button.
The SAT/MD MODE button lights.
2. Press the desired operation button.
The buttons shaded in the figure to the left are the operation
buttons that can be used to control an Onkyo MD recorder.
buttons that can be used to control an Onkyo MD recorder.
Operation buttons:
ON: Turns on and off MD player (same as STANDBY button on the
remote controller)
remote controller)
: Track down
: Track up
: Play
: Stop
: Skip backward
: Skip forward
REC
●: Record
: Pause
: Eject
1 to 9, 0, --/---: Numeric keys
ENTER: Enters the settings
You may also use the following buttons:
VOL
: Adjusts volume at TX-NR900/900E
MUTING: Activates muting function at TX-NR900/900E
Note:
The SAT/MD button is used for operating satellite tuners and Onkyo
MD recorders. Be aware that if you enter the preset code for a
satellite tuner as shown on page 70, then this button cannot be used
to operate Onkyo MD recorders.
If this is the case, to operate an Onkyo MD recorder, you must first
erase the satellite tuner code by following the directions given in
“Erasing all the commands programmed under a MODE button” on
page 75.
The SAT/MD button is used for operating satellite tuners and Onkyo
MD recorders. Be aware that if you enter the preset code for a
satellite tuner as shown on page 70, then this button cannot be used
to operate Onkyo MD recorders.
If this is the case, to operate an Onkyo MD recorder, you must first
erase the satellite tuner code by following the directions given in
“Erasing all the commands programmed under a MODE button” on
page 75.