ONKYO TX-SA605 User Guide

42

First Time Setup—Continued

Notes:
• Make sure the microphone is hori-

zontal.

• If there’s an obstacle between the 

microphone and any speaker, the 
automatic setup will not work cor-
rectly. Set up the room as you would 
when enjoying a DVD.

• Positioning the microphone close to 

where your ears would normally be 
will provide better results. You can 
adjust the height of the microphone 
by using a tripod or level table.

Press [ENTER].
The automatic speaker setup starts.

A test tone is output by each speaker in 
turn, as the Audyssey 2EQ function 
determines which speakers are con-
nected. This takes a few minutes.

Note:
If any extraneous noise is picked up by 
the microphone, the automatic setup 
may not work correctly, so don’t make 
any noise.

“Yes” means that the speaker was 
detected. “No” means that no speaker 
was detected.

tons to select Next, and then 
press [ENTER].
The options are:
Next:

Proceed to the next step.

Retry:

Return to step 2 and try again.

Cancel:

Cancel the automatic speaker setup.

(page 41), then press [ENTER].
Audyssey 2EQ performs more mea-
surements. This takes a few minutes.