Hotpoint hsh25gfb User Guide

Place the compression nut and ferrule (sleeve) onto the

end of  the tubing as shown. On a GE SmartConnect

™

Refrigerator Tubing kit, the nuts 

are already assembled to the tubing.
Insert the end of  the tubing into the refrigerator

connection as far as possible. While holding the tubing,

tighten the fitting.
For plastic tubing from a GE SmartConnect

™

Refrigerator Tubing kit, insert the molded end of  the

tubing into the refrigerator connection and tighten the

compression nut until it is hand tight, then tighten one

additional turn with a wrench. Overtightening may

cause leaks.
Fasten the tubing into the clamp provided as shown to

keep it in position. You may need to pry open the

clamp.
One of the illustrations below will look like the

connection on your refrigerator.

On models using the refrigeration connection at the

water valve, remove the plastic flexible cap.

Some models have the refrigerator connection at the

end of  tubing located outside the compressor

compartment access cover. On other models, the

compressor compartment access cover must be removed

in order to access the refrigerator connection at the

water valve.

”

”

Tighten any connections that leak.

Reattach the access cover.

”

”

Arrange the coil of  tubing so that it does not vibrate

against the back of  the refrigerator or against the wall.

Push the refrigerator back to the wall.

Slide the icemaker power switch to the ON position. The

icemaker will not begin to operate until it reaches its

operating temperature of  15°F (-9°C) 

or below. It will then begin operation automatically if

the icemaker power switch is in the ON position.