Belkin f1dv104 Quick Setup Guide
This guide will lead you through the basic steps needed to install the
ExpandView Series Video Splitter (the Splitter). If you need further
information during this installation, please refer to the Belkin User
Manual for this product.
ExpandView Series Video Splitter (the Splitter). If you need further
information during this installation, please refer to the Belkin User
Manual for this product.
You will need the following items for installation:
• OmniView ExpandView Series Video Splitter (included)
• One VGA Cable
• 9V DC, 1.5A Power Supply (included)
• OmniView ExpandView Series Video Splitter (included)
• One VGA Cable
• 9V DC, 1.5A Power Supply (included)
Introduction
Powering On the Splitter
1.
Connect the included 9V DC, 1.5A power supply to an available
power outlet.
power outlet.
2.
Attach the barrel plug into the power jack of the Splitter.
VGA 7
VGA 6
VGA 5
VGA 4
VGA 3
VGA 2
VGA 1
VGA IN
VIDEO IN
VIDEO OUT
VGA 8
Powering On the Splitter
1.
Make sure your computer is powered off.
2.
Using the OmniView Video Extension Cable (F1D9003-XX),
connect the HDDB15 male-type connector to the video card on
your computer.
connect the HDDB15 male-type connector to the video card on
your computer.
3.
Connect the HDDB15 female-type connector to the input port on
your Splitter.
your Splitter.
4.
Boot up your computer.
VGA 7
VGA 6
VGA 5
VGA 4
VGA 3
VGA 2
VGA 1
VGA IN
VIDEO IN
VIDEO OUT
VGA 8
F1DV108
F1DV104
P74184_F1DV104_108_QIG.qxd 3/10/03 3:40 PM Page 1