Craftmade uc-2000 Supplementary Manual

MODEL: UC2000-1

NOTE:  The frequencies on your Receiver and Transmitter have been preset at  
  the factory.  Before installing the Receiver, make sure the dip switches on  
  the Receiver are set to the same position on the Transmitter.  (Fig. 1)  The dip  
  switches on the Transmitter are located on one side of the control. 

Remove wall plate, disconnect and remove the toggle switch from wall junction box.

Using the wire nuts provided, make the electrical connections to the new 

Transmitter unit as shown in figure 1.

If your outlet box has a ground wire (green or bare copper),
connect the wall transmitter’s ground wire to it; otherwise
connect the wall transmitter’s ground wire directly to one of 
the screws from the outlet box.

Carefully tuck wire connections inside wall switch box.  Secure Transmitter with the 

two screws (provided).  Attach wall plate over control unit with the two screws 

previously removed (FIG 2).

Question:  Fails to operate

Answer:  Make sure all connections on Receiver and Transmitter are done correctly 

and that there are no loose wired or wire connections.  Make sure fan pull chain is 

set to the highest speed.  Make sure code switches on Receiver and Transmitter 

are set to the same code.

2. OPERATING THE TRANSMITTER
  This unit operates on a 12 volt battery (included)

a. HI, MED, and LOW buttons:

  These three buttons are used to select the fan speed.

  Press and release the button of the desired speed setting;

     HI = Highest speed

     MED = Medium speed

     LOW = Lowest speed

b.  LIGHT button:  This button will turn the light on or off and will also control the  

  brightness setting.  Press and release the button and the light will turn on or  

  cycle continuously between bright and dim settings as long as the button is  

  held down.  The light key has auto resume, it will stay at the same brightness  

  as  the last time it was turned off.

c.  FAN OFF button:  This button will turn the fan off.

d.  This remote control unit is equipped with 16 code combinations, to prevent  

  possible interference from other remote units such as garage door openers,  

  car alarm or security systems.  If your fan or light kit go on and off without  

  using your remote control, simply change the combination code in you  

  Transmitter and Receiver.

e.  Memory function

  When turning off fan or light by wall control, the fan speed and light settings  

  will be memorized and automatically recovered the next time the fan or light  

  is turned on.

Ceiling Angle Shall Not Exceed 30 Degrees For Mounting Controller.

The installation of your remote control is complete, restore power to junction box.

Do not connect to hot and common wire of electric circuit

ao switch will be damaged.  Refer to diagram below

AC120V

INPUT

WHITE

BLACK

BLACK

W

ALL

CONTROL

BLACK

WHITE

BLACK

BLACK

BLACK

GREEN

GROUND

BLUE
BLACK / RED

WHITE

BLUE

BLACK / RED

WHITE

BARE

GREEN

E1

OCT 2006

12V

+