Compex gsm8308 Specification Guide

Page of 4
 
Technote - 077 (Rev 1.0) 
GSM8308 
8-Port Gigabit Modular Layer 2/3 Switch 
DATA SHEET 
The modularity of GSM8308 Layer 2/3 switch provides a flexible solution for both 
campus  networks  and  enterprises  networks  of  all  sizes.  The  GSM8308  switch        
provides Gigabit wire-speed Layer 2 and Layer 3 switching,  based on physical     
device addresses and  IP network addresses, thus giving the utmost switching        
performance in enterprise networking.   
 
 
In large networks that handle a lot of traffic, broadcast storms can result if it is not 
properly contained. In conventional networks with routers, broadcast traffic is split up 
into separate physical domains to confine this traffic to the originating group. Instead 
of using physically separate subnets that are linked by traditional slow routers, 
GSM8308 creates segregated broadcast domains based on easily configurable 
VLANs, and links these VLANs as required with wire-speed routing. This would  
reduce the network broadcast by the switch and markedly improves the performance 
of the network.  
 
 
GSM8308 supports comprehensive layer 2 switching and management functions, 
including IEEE 802.1p/q VLAN tagging, Spanning Tree, port-trunking, and         
port-mirroring.  It  supports  Simple  Network  Management  Protocol  (SNMP)          
management and 4 groups of Remote Monitoring (RMON) and can be managed by a 
CLI through Telnet or the console port, or through a web browser graphical interface.  
 
 When GSM8308 is set to multilayer mode, it acts as a routing switch. As a layer 3 
switch, GSM8308 provides two major functions: - IP Switching and Routing Path 
Management. With IP Switching, GSM8308 basically provide wire-speed forwarding 
based on IP destination address. If packets are to be forwarded outside the switch, the 
routing path is determined by static routes manually stored in the switch, or through 
dynamic routing protocols. GSM8308 supports ICMP router discovery, Proxy ARP, 
Routing Information Protocol (RIP and RIP-2), Open Shortest Path First (OSPFv2) 
for routing path management in a network with many routers. GSM8308 does not 
support non-IP protocols such as IPX and Appletalk. 
 
 
GSM8308 supports IP multicast filtering. It does this not only by passively         
monitoring (snooping) Internet Group Management Protocol (IGMP) Query and    
Report messages and Distance-Vector Multicast Routing Protocol (DVMRP) Probe 
messages to register end-stations as multicast group members, but also by actively 
sending Generic Multicast Registration Protocol (GMRP) Query messages to learn 
the location of multicast routers/switches and member hosts in multicast groups 
within each VLAN. This is especially useful in an intensive multicast environment 
where video conferencing or data sharing is widely used. The purpose of IP multicast 
filtering is to optimize a switched network’s performance, so multicast packets will 
only be forwarded to those ports containing multicast group hosts or multicast 
routers/switches, instead of flooding traffic to all ports in the subnet.