ICOM ic-207h Instruction Manual
9
SCAN OPERATION
42
■ Skip channel setting
The memory skip function speeds up scanning by checking
only desired memory channels. Set the memory channels to
be skipped or scanned as follows.
only desired memory channels. Set the memory channels to
be skipped or scanned as follows.
➀
Push [BAND] to select the a band, if necessary.
➁
Select the memory channel to program or to cancel the
skip function on:
skip function on:
➥ Select memory mode by pushing [M/CALL] once or twice.
➥ Rotate the tuning dial to select the memory channel.
➥ Rotate the tuning dial to select the memory channel.
➂
Push [SET] one or more times until “CHS” appears as
shown above.
shown above.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to turn the skip function ON or OFF
on the selected channel.
on the selected channel.
• “~” appears
: The memory channel is skipped during
(CHS-on)
memory scan.
• “~” disappears
: The memory channel is scanned during
(CHS-OFF)
memory scan.
➄
Push [V/MHz] to exit set mode.
NOTE: Scan edge memory channels cannot be specified
as skip channels, however, they are skipped during mem-
ory scan anyway.
as skip channels, however, they are skipped during mem-
ory scan anyway.
USING
SET MODE
The display shows that
memory channel 10 is set as
a skip channel.
memory channel 10 is set as
a skip channel.
H I
M
1
9
5
SKIP
Ä
Push [BAND] to select the desired band, if nec-
essary.
essary.
Å
Select the memory channel to program or to
cancel the skip function on:
cancel the skip function on:
➥ Select memory mode by pushing [MR].
➥ Push [Y] or [Z] to select a memory channel.
➥ Push [Y] or [Z] to select a memory channel.
Ç
Push [FSET] one or more times until “CHS” ap-
pears as shown at left.
pears as shown at left.
• Pushing [GENT] reverses the order of selection
once entering set mode.
É
Push [Y] or [Z] to set or cancel the skip infor-
mation.
mation.
• See item
➃ at left for skip indicator details.
Ñ
Push [ECLR] to exit set mode.
SET
B