ICOM ic-207h Instruction Manual
14
OTHER FUNCTIONS
62
■ Squelch delay
During operation, received signal strength often fluctuates.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The IC-207H
has a built-in squelch delay function which helps prevent this.
When both stations are operating from a fixed location, this
function should be set to “short” e.g. packet operation.
This can result in annoying repeated opening and closing of
the squelch during reception of the same signal. The IC-207H
has a built-in squelch delay function which helps prevent this.
When both stations are operating from a fixed location, this
function should be set to “short” e.g. packet operation.
➀
Push [PWR] to turn power OFF.
➁
While pushing [SET], turn power ON to enter initial set
mode.
mode.
➂
Push [SET] one or more times until “Sqt” appears.
• Pushing [MONI] reverses the order of selection.
➃
Rotate the tuning dial to
set the squelch delay to
“L” (long) or “S” (short).
set the squelch delay to
“L” (long) or “S” (short).
➄
Push [PWR] momentarily
to exit initial set mode.
to exit initial set mode.
USING
INITIAL SET MODE
The display shows the squelch
delay function is set to short.
delay function is set to short.
■ Demonstration display
A demonstration function is available at power ON. This func-
tion gives you a quick visual introduction to the function dis-
play indicators.
tion gives you a quick visual introduction to the function dis-
play indicators.
➀
While pushing [BAND], push [PWR] to turn power ON.
• The transceiver cycles through a visual tour of the function dis-
play indicators.
➁
Push any switch to exit demonstration mode and enter the
normal operating condition temporarily.
normal operating condition temporarily.
NOTE: The transceiver automatically returns to demon-
stration mode after 2 min. in which no operations are per-
formed. To deactivate the demonstration display
permanently, turn power OFF, then while pushing [BAND],
turn power ON again.
stration mode after 2 min. in which no operations are per-
formed. To deactivate the demonstration display
permanently, turn power OFF, then while pushing [BAND],
turn power ON again.