ICOM ic-2100h Instruction Manual

24

5

REPEATER OPERATION

■

➀

Select the mode/channel you wish to set the subaudible
tone frequency to, such as VFO mode or memory/call
channel.

• The offset frequency can be individually programmed into each

mode or channel.

➁

Push [SET] one or more times until “DUP” appears and
flashes as shown above.

• Push [MONI] to reverse the order of selection.

• Cancel the DTMF memory encoder function in advance, if nec-

essary. (p. 45)

➂

Rotate the tuning dial to select and set the desired fre-
quency.

• Selectable step increment is the same as the preset tuning step.

(p. 16)

• Use [V/MHz] for quick MHz tuning.

➃

Push [LOW], [TONE], [M/CALL] or [PTT] to exit set mode.

The display shows that a
0.6 MHz (600 kHz) fre-
quency is set.

Ä

Set the mode/channel you wish to set the offset
frequency to, such as VFO mode, memory/call
channel or scratch pad memory.

• The offset frequency can be independently pro-

grammed into each mode or channel.

Å

Push [

F

SET] one or more times until “DUP” ap-

pears as shown at left.

• Pushing [

G

ENT] reverses the order of selection.

• Cancel the DTMF memory encoder function in ad-

vance, if necessary. (p. 44)

Ç

Push [

Y

] or [

Z

] to select and set the desired

frequency.

• Selectable step increment is the same as the preset

tuning step. (p. 16)

• Pushing and holding [

Y

] or [

Z

] changes the fre-

quency continuously.

É

Push [

E

CLR] to exit set mode.

☞

NOTE: The offset frequency can be set in a memory chan-
nel temporarily. However, the set contents are cleared
once the memory/call mode is selected. To store the offset
frequency permanently, overwrite the channel information.

SET

B