ICOM ic-2100h Instruction Manual

38

9

SCAN OPERATION

■

Scan edges can be programmed in the same manner as
memory channels. Scan edges are programmed into scan
edges, 1A/1b to 3A/3b, in memory channels.

➀

Set the desired frequency in VFO mode:

➥

Set the frequency using the tuning dial.

➥

Set other data (e.g. offset frequency, etc.) if desired.

➁

Push [S.MW] momentarily.

• “

!

” and the memory channel number flash.

➂

Rotate the tuning dial to select a scan edge channel.

➃

Push [

(S.MW)

MW] for 1 sec. to program.

• 3 beeps may sound and the frequency is programmed.

• Scan edge 1b is automatically selected when continuing to push

[

(S.MW)

MW] after programming.

➄

To program a frequency for the other pair of scan edges,
1b to 3b, repeat steps 

➂

and 

➃

.

• If the same frequency is programmed into a pair of scan edges,

programmed scan will not function.

[EXAMPLE]: Programming 145.30 MHz and 145.80 MHz into scan edges 1A and 1b, respectively.

Rotate

Rotate

Push

momentarily

and hold

continue pushing

Program 1b in the same manner.

Push