ICOM ic-2100h Instruction Manual

55

14

■

You can select silent operation by turning beep tones OFF or
you can select to have confirmation beeps sound at the push
of a switch by turning beep tones ON.

➀

Push [PWR] to turn power OFF.

➁

While pushing [SET], turn power ON to enter initial set
mode.

➂

Push [SET] one or more times until “BEP” appears.

• Pushing [MONI] reverses the order of selection.

➃

Rotate the tuning dial to se-
lect the condition.

• “BEP--OF”: Beep tones are

turned OFF.

• “BEP--ON”: Beep tones are

turned ON.

➄

Push [PWR] to exit initial set mode.

The display shows that beep
tones are turned ON.

■

To prevent accidental prolonged transmission with the one-
touch PTT function, etc., the transceiver has a time-out timer.
This timer cuts a transmission OFF after 3, 5, 15 or 30 min. of
continuous transmission. This timer can be cancelled (de-
fault).

Approx. 10 sec. before the time-out timer is activated, the
transceiver emits a beep tone as a warning.

➀

Push [PWR] to turn power OFF.

➁

While pushing [SET], turn power ON to enter initial set
mode.

➂

Push [SET] one or more times until “TOT” appears.

• Pushing [MONI] reverses the order of selection.

➃

Rotate the tuning dial to select the desired time-out time or
turn the timer OFF (“OF”).

➄

Push [PWR] to exit initial set mode.

The display shows that the 5
min. timer is selected.

The display shows that the
time-out timer is cancelled.