ICOM ic-2720h Instruction Manual
4
1
PANEL DESCRIPTION
New2001
1
tAM INDICATOR (p. 64)
Appears when AM mode is selected.
yFREQUENCY READOUT
Shows the operating frequency, set mode contents, etc.
• Frequency decimal point blinks while scanning. (p. 41)
• “d” appears in place of the 1st digit while the DTMF memory
• “d” appears in place of the 1st digit while the DTMF memory
function is in use. (p. 48)
uMEMORY CHANNEL NUMBER INDICATORS
➥ Shows the selected memory channel number. (p. 29)
➥ Shows the selected bank initial. (p. 35)
➥ “C” appears when the call channel is selected. (p. 38)
➥ “L” appears when the lock function is activated. (p. 15)
iSKIP INDICATOR (p. 44)
Appears when the displayed memory channel is specified
as a skip channel.
as a skip channel.
oMEMORY INDICATOR (pgs. 12, 29)
Appears when memory mode is selected.
!0S/RF INDICATORS
➥ Shows the relative signal strength while receiving sig-
nals. (p. 16)
➥ Shows the output power level while transmitting. (p. 20)
!1OUTPUT POWER INDICATORS
“LOW” appears when low output power; “MID” appears
when middle output power is selected.
No indicator appears when high output power is selected.
when middle output power is selected.
No indicator appears when high output power is selected.
!2BUSY INDICATOR
➥ Appears when a signal is being received or the squelch
is open. (p. 16)
➥ Blinks while the monitor function is activated. (p. 16)
IC-2720H_2.qxd 03.5.13 9:45 Page 4 (1,1)