ICOM ic-2720h Instruction Manual

12

2

SETTING A FREQUENCY

New2001

z Push [BAND] to select main band.

x Push [FUNC], the push [

BANK

1(MONI)] to se-

lect frequency band selecting condition.

• The frequency band initial is displayed.

c Push [Y]/[Z] to select the desired frequency

band.

v Push [

CLR

A(MW)] to exit the condition, and re-

turn to frequency indication.

✔

In addition to the 2 m and 70 cm ham bands, the IC-2720H
USA and General versions have extra frequency bands for
each left and right bands as follow.

See the specifications for the available frequency bands for
details.

*The frequency band initials are default indication only. Once the op-

erating frequency is set in the band, the initial indication will be
changed.

✔: Available, —: Not available

D VFO and memory modes

The transceiver has 2 basic operating modes: VFO mode and
memory mode. Select VFO mode first to set an operating fre-
quency.

➥ Push the desired band’s [V/MHz•SCAN] to select VFO

mode.

• When VFO mode is already selected, the digit below 10 MHz

(the digit below 1 MHz or 100 kHz disappear depending on ver-
sions) disappear. In this case, push [V/MHz•SCAN] again (or
twice or 3 times depending on version).

➥ Push [M/CALL•MW] to select memory mode.

• “!” indicator appears when memory mode is selected.

➥ Push [VFO/LOCK] to select VFO mode.

➥ Push [MR/CALL] to select memory mode.

• The microphone controls the main band only. Push

[BAND] to toggle the main band, then push
[VFO/LOCK] or [MR/CALL], if necessary.

VFO/LOCK

Push [M/CALL•MW]
to select memory mode

VFO mode is selected

“!” indicator appears when
memory mode is selected

Push [V/MHz•SCAN] 
to select VFO mode

BANK

[Y]/[Z]

127

✔

✔

222

✔

—

375

✔

✔

500

✔

✔

900

—

✔

IC-2720H_2.qxd  03.5.13 9:45  Page 12 (1,1)