ICOM ic-2720h Instruction Manual
27
4
REPEATER OPERATION
New2001
■ Offset frequency
When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
Independent offset frequencies can be set for each operating
frequency.
quency is shifted from the receive frequency by an amount
determined by the offset frequency.
Independent offset frequencies can be set for each operating
frequency.
q Push [MAIN•BAND] to select the desired band (left or right)
as the main band.
• Push [MAIN•BAND] for 1 sec. then rotate the [DIAL] to select the
desired frequency band if necessary.
w Select the desired mode/channel you wish to set the offset
frequency to, such as VFO mode or memory/call channel.
• The offset frequency can be independently programmed into
each mode or channel.
e Push [SET•
] to enter set mode.
r Push [SET•
] or [LOW•PRIO] until “DUP” and offset fre-
quency appear.
t Rotate the main band’s [DIAL] to set the desired offset fre-
quency.
y Push [TONE•DTMF] to exit set mode.
z Push [BAND] to select the desired band (left or
right) as the main band.
• Enter the desired frequency via the keypad if neces-
sary.
x Select the desired mode/channel you wish to
set the offset frequency to, such as VFO mode
or memory/call channel.
or memory/call channel.
• The offset frequency can be independently pro-
grammed into each mode or channel.
c Push [
SET
B(D-OFF)] to enter set mode.
v Push [
SET
B(D-OFF)] or [
ENT
C(T-OFF)] until
“DUP” and offset frequency appear.
b Push [Y] or [Z] to set the desired offset.
• Direct frequency entry from the keypad is not possi-
ble.
n Push [
CLR
A(MW)] to exit set mode.
☞NOTE: The offset frequency can be set in a memory/call
channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.
MAIN
T X
DUP
M
Push
SET
B
MAIN
T X
DUP
M
[SET• ]
[LOW•PRIO]
“DUP” and offset frequency appear
USING
SET MODE
IC-2720H_2.qxd 03.5.13 9:45 Page 27 (1,1)