Olympus 1030 sw Quick Setup Guide
EN
47
Usi
ng OLY
ng OLY
M
PU
S Mast
S Mast
er
Note
• Use a computer with a pre-installed operating system. Operations are not guaranteed on
home-built computers or computers with an updated operating system.
• Operations are not guaranteed when using an added USB or IEEE 1394 (FireWire) port.
• To install the software, you must log on as a user with administrators’ privileges.
• If you are using Macintosh, be sure to remove the media (drag & drop onto the trash icon)
• To install the software, you must log on as a user with administrators’ privileges.
• If you are using Macintosh, be sure to remove the media (drag & drop onto the trash icon)
before performing the following operations. Failure to do so could result in unstable computer
operation and the need to reboot.
operation and the need to reboot.
• Disconnect the cable connecting the camera to the computer
• Turn off the camera
• Open the camera’s battery/card compartment cover
• Turn off the camera
• Open the camera’s battery/card compartment cover
1
Make sure the camera is turned off.
• The monitor is off.
• The lens cover is closed.
• The lens cover is closed.
2
Connect the multi-connector on the camera to
the USB port on the computer using the
provided USB cable.
the USB port on the computer using the
provided USB cable.
• Refer to your computer’s instruction manual to locate the
position of the USB port.
• The camera turns on automatically.
• The monitor turns on and the selection screen for the USB
• The monitor turns on and the selection screen for the USB
connection is displayed.
3
Select [PC], and press
o.
Connecting the camera to a computer
For how to install the OLYMPUS Master software, refer to the installation guide
included in the CD-ROM.
included in the CD-ROM.
Monitor
Connector cover
Multi-connector
EASY PRINT
USB
SET
OK
EXIT
CUSTOM PRINT
PC
d4354_e_0000_7.book Page 47 Thursday, December 20, 2007 10:25 AM