Pioneer VSX-21TXH User Guide
Using other functions
08
72
En
Resetting the system
Use this procedure to reset all the receiver’s settings to
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
the factory default. Use the front panel controls to do this.
Set MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory device from
the receiver beforehand.
1
Switch the receiver into standby.
2
While holding down ENTER on the front panel,
press
STANDBY/ON.
The display shows RESET
NO .
3
Select ‘RESET’ using PRESET +/–, then press ENTER
on the front panel.
The display shows RESET? OK.
The display shows RESET? OK.
4
Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
has been reset to the factory default settings.
• Note that all settings will be saved, even if the
receiver is unplugged.
Default system settings
Setting
Default
Digital Video Conversion
ON
SPEAKERS
A
Surround Back System
Normal
Speaker System
Front
SMALL
Center
SMALL
Surr
SMALL
SB
SMALLx2
SW
YES
Crossover
80 Hz
X-Curve
OFF
THX Audio Setting
4 ft<
DIMMER
Brightest
Inputs
See Input function default and possible settings on page 44.
MULTI-ZONE
ZONE 2/ZONE 3 (VSX-23TXH only) Volume
Level
Level
Variable
ZONE 2/ZONE 3 (VSX-23TXH only) Volume
–60 dB
HDMI
HDMI Audio
Amp
HDMI output (VSX-23TXH only)
HDMI OUT ALL
KURO LINK
ON
DSP
Surround back channel Processing
ON
Phase Control
ON
Sound Retriever
iPod/USB function
ON
Other functions
OFF
Sound Delay
0.0 frame
Dual Mono
CH1
DRC
AUTO
SACD Gain
0 dB
LFE Attenuate
0 dB
Auto delay
OFF
Up Mix
ON
Digital Safety
OFF
Effect Level
EXT.STEREO
90
Other modes
50
2 PL II Music
Options
Options
Center Width
3
Dimension
0
Panorama
OFF
Neo:6 Options
Center Image
Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs
Listening Mode
(2 ch)
(2 ch)
AUTO
SURROUND
SURROUND
Listening Mode
(x ch)
(x ch)
AUTO
SURROUND
SURROUND
Listening Mode (HP) STEREO
See also Setting the Audio options on page 66 for other default
DSP settings.
DSP settings.
MCACC
MCACC Position Memory
M1: MEMORY 1
Channel Level (M1 to M6)
0.0 dB
Speaker Distance (M1 to M6)
10’00”
Standing Wave
(M1 to M6)
(M1 to M6)
ATT of all channels/
filters
filters
0.0 dB
SWch Trim
0.0 dB
EQ Data (M1 to M6)
All channels/bands
0.0 dB
EQ Trim
0.0 dB
Setting
Default
VSX-23TXH_CUXJ.book 72 ページ ２００９年５月８日 金曜日 午前１０時４５分