Pioneer pdp-4270hd User Guide

En

You need to make this connection, so that the TV Guide On 
Screen™ system works with the Plasma Display System to 
enable the system’s recording features with your VCR.

• In order to use your VCR with the TV Guide On Screen™ 

system, you have to correctly set up for the TV Guide On 
Screen™ system. See “TV Guide On Screen™ System Setup” 
on page 38.

• Make sure to position the G-LINK cable’s wand so that its 

light emitting section faces the remote control sensor on the 
VCR.

• Make sure to place the VCR into the standby status when 

presetting TV programs for recording with the TV Guide On 
Screen™ system.

• Be careful not to leave the cable looped when making the 

connection.

Attaching the ferrite core

To help prevent noise, attach the supplied ferrite core to the 
connector end of the G-LINK cable as shown.

• Regarding the G-LINK cable, attach the supplied ferrite core.

If you do not do this, this Plasma Display will not conform to 
mandatory FCC standards.

When connecting the VCR

720 

× 400

70 Hz

640 

× 480

60 Hz

72 Hz

75 Hz

800 

× 600

56 Hz

60 Hz

72 Hz

75 Hz

1024 

× 768

60 Hz

70 Hz

75 Hz

1360 x 768

60 Hz

G-LINK cable

Ferrite core

As close as possible

Pull the cable slightly to 

take up any slack 

.

A

A

AV cable 
(commercially 
available)

G-LINK cable (supplied)

Point to the remote 
control sensor

G-LINK cable’s wand

Viewed from below of 
the Plasma Display

12_Enjoying.fm  Page 76  Wednesday, May 24, 2006  11:11 AM