TOA bs-1030 User Manual
6
6.3. Installation Procedures
Step 1. Base frame mounting
• The base frame can be mounted on the wall directly or using a commercial two-gang electrical box.
• The base frame hole (21.6 mm in diameter) can also be used for conduit fitting.
• The base frame hole (21.6 mm in diameter) can also be used for conduit fitting.
Conduit
Base frame
Step 1-1. Run the speaker cables from the wall through the base frame hole (21.6 mm in diameter), then strip
the cables about 5 mm from the cable end.
• Usable cable: Solid or stranded cable (0.2 – 2.5 mm
• Usable cable: Solid or stranded cable (0.2 – 2.5 mm
2
corresponding to AWG24 – 14)
Step 1-2. Mount the base frame on the wall using four screws.
Notes
• The speaker cannot be mounted if the base frame is not properly positioned. Ensure that the base
• The speaker cannot be mounted if the base frame is not properly positioned. Ensure that the base
frame hole is situated on the upper side of the frame when mounted.
• Use nuts and bolts (not supplied with the unit for direct wall mounting) that are appropriate for the
structure and composition of the wall.
• When using two-gang electrical box, use either the supplied "M4 machine" or "Unified" screw
depending on the type of electrical box.
• Protect the H-3WP from rain when installing it outdoors. (Refer to p. 10 "Waterproofing the base
frame.")
Speaker cable
About 5 mm
Use screws that are appropriate
for the structure of the wall.
for the structure of the wall.
[Direct wall mounting]
[Wall mounting by means of a commercial two-gang
electrical box]
Two-gang electrical box
Speaker cable
Base frame
Use either the supplied M4 machine screw or Unified
screw depending on the type of electrical box.
screw depending on the type of electrical box.