ConnectGear gr-104 User Guide
30
2.2.6 Bridge
The bridge mode screen allows you to set your Broadband router to bridge mode and allows you
to assign an IP address for management purposes. When the bridge mode is selected, the router
in effect becomes a switch, transferring packets from the WAN port to the LAN port and vice
versa without any NAT involvement. In bridge mode, the original WAN MAC is ignored, and the
original LAN MAC address will be used as the MAC address. These values will be restored when
you set the device to operating modes other than the bridge mode.
to assign an IP address for management purposes. When the bridge mode is selected, the router
in effect becomes a switch, transferring packets from the WAN port to the LAN port and vice
versa without any NAT involvement. In bridge mode, the original WAN MAC is ignored, and the
original LAN MAC address will be used as the MAC address. These values will be restored when
you set the device to operating modes other than the bridge mode.
Parameters
Description
IP address
Enter an IP Address for the Bridge Mode. This IP address allows
you to access the web-based management should you decide to
switch back to the router mode.
you to access the web-based management should you decide to
switch back to the router mode.
Subnet Mask
The Subnet Mask for the Bridge Mode management
Click <Apply> at the bottom of the screen to save the above configurations. You can now
configure other advance sections or start using the router (with the advance settings in place)
configure other advance sections or start using the router (with the advance settings in place)