Cma -180uc Hardware Manual
Parts Manual
1.3.
Optional Drain Pump—I
NSTALLATION
I
NSTRUCTIONS
1. Start by removing the existing drain hose from the Drain Valve as shown in
Figure 1
.
From Scrap Tray
Figure 1
2. Locate the white and purple wires that are safe-ended and tie-wrapped at the top of the Drain
Pump compartment. Bring these wires out so they can be connected after mounting the Drain
Pump.
Pump.
3.
Connect the 3-inch long pump inlet drain hose to the Drain Valve and mount the Drain Pump
using the nuts and washers provided with the kit as shown in
using the nuts and washers provided with the kit as shown in
Figure 2
.
Figure 2
4.
Remove the terminal cover and connect the white and purple wires to the two white wires
from the pump. Replace the cover.
from the pump. Replace the cover.
White wire
Purple wire
Remove this cover to
make wire connections.
make wire connections.
Tighten this
hose clamp
over Drain
Valve.
3-inch pump
inlet drain
hose.
From Wash Tank
Remove
Drain hose must elevate
12 to 16 inches before
dropping to drain.
12 to 16 inches before
dropping to drain.
MODEL CMA-180UC PARTS MANUAL Rev. 1.14
Page 5