Cma -44l Owner's Manual
Getting Started
2.2.
Receiving and Installation
When you receive your new CMA-44, complete the assembly by installing the scrap tray
assembly with its overflow chute, the two wrapper shields and the curtain rods, which are shipped
inside the machine. After the box has been removed from the machine, remove the left and right
stainless steel wrapper shields and bolt them in place with the nuts and bolts provided. The
wrapper shield with the extra curtain clamps mounts onto the dirty end of the machine. Next,
mount the scrap tray assembly and overflow chute into position (see section
assembly with its overflow chute, the two wrapper shields and the curtain rods, which are shipped
inside the machine. After the box has been removed from the machine, remove the left and right
stainless steel wrapper shields and bolt them in place with the nuts and bolts provided. The
wrapper shield with the extra curtain clamps mounts onto the dirty end of the machine. Next,
mount the scrap tray assembly and overflow chute into position (see section
All of the spray arms should be inserted and in place over the wash tank compartments.
There are a total of four curtains used in the CMA-44; two are long- narrow, two are short- wide.
The two long-narrow curtains have shorter rods than the other two curtains. The short rods hold
the curtains at the entrance and exit of the machine.
The two long-narrow curtains have shorter rods than the other two curtains. The short rods hold
the curtains at the entrance and exit of the machine.
The sketch below lists curtain positions 1 through 4.
CMA-44
1
2
3
4
LONG-NARROW
CURTAIN
DISH FLOW
DISHMACHINE FRONT VIEW
SHORT-
WIDE
CURTAINS
LONG-NARROW
CURTAIN
CURTAIN
MODEL CMA-44 Installation & Operation Manual Rev. 2 .15 10/18/07
Page
4