TI -5032svc Owner's Manual

5032UENG.DOC   New 11-language guidebook   Robin Hunt-Smith   Revised: 07/24/98 3:51 PM   Printed: 06/23/00 12:32 PM   Page 1 of 6

1. Set 

.

2. Connect the adapter cord to the socket on the back of

the calculator.

3. Plug the adapter into an electrical outlet.

4. Set 

, 

, or 

.

Warning: Using any AC adapter other than the appropriate
TI adapter may damage the calculator and void the
warranty.

1. Set 

.

2. If the AC adapter is connected, unplug it.

3. Turn the calculator over and remove the battery

compartment cover.

4. Remove the old batteries, if necessary.

5. Position new batteries as shown in the diagram inside

the battery compartment. Pay close attention to the
polarity (+ and – symbols).

6. Replace the battery compartment cover.

7. Set 

, 

, or 

.

Texas Instruments recommends you use alkaline batteries
for longer battery life.

To avoid paper jams, use quality bond paper. A 2¼-inch
roll of quality bond paper is included with your calculator.

1. Set 

.

2. Cut the end of the paper squarely.

3. Holding the paper so it unrolls from the bottom, insert

the end of the paper firmly into the slot on the back of
the calculator.

4. While feeding the paper into the slot, press 

&

 until

the paper is in position.

5. Lift the metal paper holder so it extends behind the

printer compartment.

6. Place the paper roll on the paper holder.

7. To print, set 

 or 

.

Note: To prevent damage to the printer (which may void
the warranty), set 

 rather than 

 or 

 when

operating the calculator without paper.

The printer uses a 2-color ink roller (IR-40T). Negative
entries and results are printed in red. All other numbers
are printed in black. If the printing becomes faint, you may
need to replace the ink roller.

1. Set 

.

2. Remove the clear plastic printer-compartment cover.

(Press down and push back to slide the cover off.)

3. Remove the old ink roller by lifting the tab (labelled

) on the left side of the roller.

4. Position the new ink roller and gently press down until

it snaps into place on both sides.

5. Replace the cover.

6. Set 

 or 

.

Warning: Never refill or moisten the ink roller. This may
damage the printing mechanism and void the warranty.