Coby cx-cd236 User Manual

- 8 -

Do  not  force  the  CD  door  open  or 

closed at any time.
Keep  the  CD  door  closed  when  the 

unit is not in use to prevent dirt and 

dust from entering the CD compart-

ment.
Do not put anything other than a CD 

in the CD compartment as other ob-

jects  may  damage  the  play  mecha-

nism.
Never insert more than one CD at a 

time.
If  a  CD  is  deeply  scratched  or  too 

dirty, it may not play (see the Care & 

Maintenance  section  for  more  infor-

mation). 
Never  remove  a  CD  from  the  com-

partment while it is still spinning.

•

•

•

•

•

•

Notes

CD OPERATION

Press the OPEN/CLOSE CD Door button to open 

the CD door. 
Place the CD in the compartment with the label 

side facing up.
Close the CD door. Once the door is closed, the 

CD will spin briefly and the total number of tracks 

on the CD will be shown on the LED Display.

Load  a  CD  and  press 

  to  start  playback.  The  LED 

Display will show the track number being played.

To pause playback, press 

. To resume play-

back, press 

 again.

To select the next track, press 

. To fast forward 

through a track, press and hold 

.

To select the previous track, press 

. To reverse 

through a track, press and hold 

.

To stop playback, press  .

You can set the unit to play a tracks repeatedly. Press REPEAT to cycle through the different Repeat mode op-

tions. To cancel Repeat mode, press REPEAT until the Repeat All/One indicator on the display turns off.

Repeat All (Steady LED): Plays the entire CD repeatedly. If the unit is in Program mode, the unit will play 

the entire Program list repeatedly (see the Program Mode section for more information).
Repeat One (Blinking LED): Plays a single track repeatedly.

You can set the unit to play tracks on the CD in a predeter-

mined order. To create a programmed track list:

Press   to make sure that the CD has stopped 

playing.
Press PROG once. The Program LED indicator will 

start blinking and the LED Display will show “0”.
Press FWD or PREV to select a track to program 

(the LED display will show the track number) and 

then press PROG to add the track to the program 

list. 
Repeat Step 3 until you have finished adding tracks 

to the program list. 
Press 

 to start Program mode playback. To cancel Program mode playback, press   twice or open 

the CD door.

•

•

•

•

•

•

•

•

•

1.

.

3.

.

.

The  program  list  can  store  a  maxi-

mum of 20 tracks.
The program list will be lost if STOP 

is  pressed  twice,  the  CD  door  is 

opened, or the unit is turned off.
If 

 is pressed before PROG dur-

ing track selection, the track will not 

be added to the program list. The unit 

will start playing the CD from the first 

selected track instead.

•

•

•

Notes