Epson DFX-9000 Reference Guide
Paper Handling
13
2
2
2
2
2
2
2
2
2
2
2
Chapter 2
Paper Handling
Using the Two-Tractor System
Your printer’s paper handling system consists of a front push
tractor and a rear push tractor. Both tractors are easy to load and
operate, and both accommodate a wide variety of paper types,
including labels and multi-part forms.
tractor and a rear push tractor. Both tractors are easy to load and
operate, and both accommodate a wide variety of paper types,
including labels and multi-part forms.
The printer automatically adjusts to the thickness of the paper
loaded when the platen gap setting is set to Auto (the default) in
SelecType mode. See “Using SelecType” on page 84 for more
information.
loaded when the platen gap setting is set to Auto (the default) in
SelecType mode. See “Using SelecType” on page 84 for more
information.
You can print on continuous paper from 76.2 mm (3 inches) to
419.1 mm (16.5 inches) wide. Your printer senses the paper
width automatically.
419.1 mm (16.5 inches) wide. Your printer senses the paper
width automatically.
When using more than two types of paper, load the paper you
use most often onto the front tractor. The front tractor, which is
easier to reach, will be available for the paper you change more
frequently.
use most often onto the front tractor. The front tractor, which is
easier to reach, will be available for the paper you change more
frequently.
Note:
❏ Before using your paper, check that it matches the specifications
❏ Before using your paper, check that it matches the specifications
described in this manual. See “Paper” on page 167 for details.
Also make sure your paper has a straight edge.
Also make sure your paper has a straight edge.
❏ If continuous paper is fed past the sprocket (on the last page, for
example), the paper may not feed properly.
❏ When the optional perforation cutter (#C81507X) is installed,
the printable width is from 101.6 mm (4 inches) to 406.4 mm
(16 inches).
(16 inches).