Epson R2880 Quick Setup Guide
4
Remove only the yellow tape from each cartridge.
Caution: Don’t remove any
seals from the cartridge or
ink will leak.
seals from the cartridge or
ink will leak.
5
Insert the cartridges in the holder for each color.
6
Press the cartridges down until they click.
7
Close the cartridge cover and press it down until it clicks.
8
Close the printer cover.
9
Press
the
ink button to charge the ink. Charging takes about
3 minutes.
Caution: To conserve ink, don’t turn off the printer while
the
the
power light is flashing.
Check your packaging carefully for all 9 cartridges. If anything is missing,
contact Epson as described on the back.
contact Epson as described on the back.
Remove all the tape and packing material. (There may be more tape on
the printer than is shown below.)
the printer than is shown below.)
Unpack
1
1
Plug in the power cable.
2
Press
the
power button.
Turn on the power
2
*411333100*
*411333100*
There are eight cartridge slots in the printer, but nine cartridges are
included. One slot can use either the Photo Black cartridge or Matte Black
cartridge. Install the Photo Black cartridge to print on glossy and luster
paper. Install the Matte Black cartridge to print on matte and fine art paper.
included. One slot can use either the Photo Black cartridge or Matte Black
cartridge. Install the Photo Black cartridge to print on glossy and luster
paper. Install the Matte Black cartridge to print on matte and fine art paper.
Caution: Do not open an ink cartridge package until you are ready to
install the ink. Cartridges are vacuum packed to maintain reliability.
install the ink. Cartridges are vacuum packed to maintain reliability.
Don’t load paper before installing ink cartridges.
1
Open the printer cover, then open the cartridge cover.
2
Shake the ink cartridges four or five times. (All cartridges make a
clicking sound when you shake them.)
clicking sound when you shake them.)
3
Unpack the ink cartridges.
Install ink cartridges
3
Sheet feeder
You can load plain paper, and most glossy and matte papers, in the
sheet feeder.
sheet feeder.
1
Open the paper support and pull up the extensions.
2
Open the output tray and pull out the extensions.
3
Load paper against the right edge and behind the tab. Then squeeze
the edge guide and slide it to the edge of the paper.
the edge guide and slide it to the edge of the paper.
Note:
Don’t load the paper sideways. Always
load it short edge first.
Rear Manual feed slot
You can print on these paper types using the single sheet guide and the
rear manual feed slot:
rear manual feed slot:
•
Epson Velvet Fine Art Paper
•
Epson Watercolor Paper Radiant White
•
Epson UltraSmooth
®
Fine Art Paper 325 gsm
•
PremierArt
™
Matte Scrapbook Photo Paper for Epson
•
Epson Exhibition Fiber Paper
1
Remove any paper from the sheet feeder and close the paper support.
2
Make sure the output tray is open and the extensions are pulled out.
Load paper
4
4113331 Rev.0
1-F
1-F
C
4113331 Rev.0
1-F
1-F
M
4113331 Rev.0
1-F
1-F
Y
4113331 Rev.0
1-F
1-F
K
Start Here
Epson Stylus
®
Photo R2880