Epson 10000XL User Manual

Using Optional Equipment

4. Plug in the scanner and reconnect its cables.

5. Initialize the card by holding down its 

RESET

 button (to the right of the 

connector) while you turn on the scanner. Continue holding down the button for 
about 10 seconds, until the card’s red and green lights (to the left of the 
connector) turn on.

Now you’re ready to connect the scanner to your network. 

1. Turn off the scanner.

2. Connect an Ethernet cable (Category 5 

unshielded twisted-pair) to the RJ-45 
jack on the card, and then connect the 
other end to a hub on your network.

Note: To prevent corruption of scanned 
data, you must use a Category 5 cable. 
Do not connect the scanner directly to 
your computer; instead, connect it to the 
network through an existing hub.

3. Turn on the scanner.

4. Check the lights on the card. Initialization is in progress while the red and green 

lights are on. When the yellow light comes on, initialization is complete.

5. Assign the card an IP address. See the Network Image Express Card User’s Guide for 

instructions. Be sure to note the address, as you’ll need it in the next section.

10000XL.book  Page 62  Friday, June 4, 2004  1:57 PM