Epson 1000 ICS User Guide

Problems and Solutions

Your EPSON software may be incorrectly installed. See 
page 48 to uninstall your software. Make sure you follow 
the steps on your Start Here poster carefully when you 
reinstall your software. You need to connect the EPSON 
1000 ICS at the correct time during installation so that it 
is detected by the driver. 

■

Make sure your system meets the requirements 
beginning on page 51. Close your other applications, 
including any screen savers and virus protection 
software and install again.

■

Make sure that the Universal Serial Bus (USB) 
Controller is working properly in Device Manager; see 
your computer documentation. If it is not working, 
contact your computer dealer. 

■

If you see an error message or the software 
doesn’t install correctly on Windows XP or 
Windows 2000, you may not have software 
installation privileges. 

■

If you’re printing over a network, see your electronic 
Reference Guide for instructions on configuring your 
EPSON 1000 ICS for use on a network. 

■

It takes several minutes to install the software. Don’t 
cancel the installation or open any other programs 
during the installation process. 

Only the POperate light 
is on, but nothing prints.

■

Make sure the USB cable is connected securely and 
that the cable meets the system requirements on 
page 51.

■

Run a nozzle check as described on page 39. If the 
check page prints, make sure your EPSON 1000 ICS 
software is installed correctly. 

■

If you’re printing on a network, you need to set up 
your EPSON 1000 ICS for network printing, as 
described in your electronic Reference Guide.