Epson CX5200 Quick Setup Guide
1
Insert the paper support into its two grooves.
2
Set the feeder guard into its two slots in front of the
paper support.
paper support.
3
Open the output tray and pull out the extension.
EPSON Stylus
®
CX5200
Start Here
1
Press and hold the On button for 2 seconds. The green light flashes
and the scanner carriage and print head move.
and the scanner carriage and print head move.
2
Lift up the entire scanner unit.
3
Shake the package of ink cartridges four or five times.
Then remove the cartridges from the package.
Then remove the cartridges from the package.
Caution: You must install all cartridges and leave them installed
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
for all types of printing. To avoid damaging the Stylus CX, never
move the print head by hand.
4
Lower each cartridge into
its holder as shown.
its holder as shown.
5
Press down on each cartridge
until it is firmly seated.
until it is firmly seated.
Install Ink Cartridges
5
1
Flip the feeder guard forward.
2
Slide out the edge guide.
3
Place a stack of paper against the right side of the feeder,
but don’t push it in. Slide the edge guide against the paper.
but don’t push it in. Slide the edge guide against the paper.
4
Flip the feeder guard back over the stack of paper.
1
Open the scanner lid, as shown.
Remove any packing materials
under the lid.
Remove any packing materials
under the lid.
2
Slide the transportation lock
back to the unlock position.
back to the unlock position.
Caution: Make sure you
unlock the scanner, or it
won’t work.
unlock the scanner, or it
won’t work.
3
Close the scanner lid.
1
Make sure you have all the parts shown here. If any parts are missing,
contact EPSON as described on the back of this sheet.
contact EPSON as described on the back of this sheet.
2
Remove any tape and packing materials, as shown.
Note: Make sure you remove all the tape. There may be packing
materials or tape in different locations. Do not remove the sticker
covering the USB port yet.
materials or tape in different locations. Do not remove the sticker
covering the USB port yet.
3
Lift up the entire scanner unit.
4
Peel off the tape from the ink cartridge holder and from the top of the
printer. Make sure you don’t leave any tape inside.
printer. Make sure you don’t leave any tape inside.
5
After you have removed all the packing materials, lower the
scanner unit.
scanner unit.
Unpack
Unlock
Turn over
1
Plug the Stylus CX into a grounded electrical outlet.
Do not connect the USB cable yet.
Do not connect the USB cable yet.
Plug In
1
2
2
4
6
Load Paper
6
Lower the scanner unit.
The Stylus CX begins charging the ink delivery system.
Charging takes about 2 minutes. The green light flashes and the
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
Stylus CX makes various sounds. Don’t turn it off while the green
light is flashing or you’ll waste ink.
continued
Attach the Parts
3
Paper support
USB cable
Software
CD-ROM
CD-ROM
Booklet
EPSON Stylus CX5200
Ink cartridges
Feeder guard
Press the
On button
On button
continue
Don’t remove
this sticker yet
this sticker yet
Don’t touch the green part
4040293-00 CPD-15142R1