Epson CX6500 Quick Setup Guide

Cautions and Notes

Cautions must be observed to avoid damage to your
equipment.

Notes contain important information and useful tips on the
operation of this product.

Unpacking

Make sure the following parts are included and not damaged.

Removing the Tapes

1. Open the scanner unit.

2. Remove all tape and packing material from this product. Make

sure the protective materials around the ink cartridges are
removed.

Setup

4049504-00
XXX

power cord

paper support

ink
cartridges

feeder guard

CD-ROM

The body color and contents may vary in certain
locations.
The power cord comes attached in some
countries.

Do not Touch or remove.

Attaching the Parts

1. Attach the paper support.

2. Insert the feeder guard into two slots in front of the paper

support.

Note:
The feeder guard prevents items put on the document cover
from getting into the inside of this product.

Turning On

Plug in the power cord and press the P On button to turn on this
product.

Note:
Do not connect it to your computer before step

or you will

fail to install the software.

Installing Ink Cartridges

1. Open the scanner unit.

2. Shake an ink cartridge four or five times and then remove it from

its package.

Press

Do not touch

3. Open the cartridge cover.

4. Place each cartridge into its holder. Then, push the ink cartridge

down until it clicks into place.

Note:
Install all ink cartridges. This product does not work unless all
cartridges are installed properly.

5. Close the cartridge cover.

6. Lower the scanner unit.

Ink charging starts and it takes about two minutes to complete.

Initial charge...

appears on the LCD panel and the Stylus CX

produces a variety of mechanical sounds. This is normal.

Caution:
❏ Never turn off this product during the ink charging

process.

❏ Do not load paper until ink charging is complete.

Selecting a Language

1. Press the Setup button and

A button until 7.Languages
appears on the LCD panel
and then press the x Color
button.

2. Select a language by

pressing the D button.

3. Press the OK button.

Menu items appear in the selected language.

Loading Paper

1. Slide out the output extension tray.

2. Move the feeder guard towards you.

3. Slide out the edge guide.

4. Load a stack of paper to rest against the right side of the feeder

and slide the edge guide against the paper.

5. Move the feeder guard back.

Now you are ready to use this product as a stand-alone device.
See the next section to learn how to make a test copy. If you want
to install software, see “Connecting to Your Computer” on the
reverse side of this sheet.

Making Copies

1. Place a document on the document table.