Epson 1000 Product Datasheet

ActionLaser 1000/1500

Epson GL Identity card (C826021)

If you have an ActionLaser 1000, the Epson GL identity card

allows you to use your printer in the Epson GL emulation.
EPSON Type B Interface boards
If you would like to use this printer with three computers or

use this printer to connect two serial or two parallel interfaces

at the same time, install one of these interfaces:

C823071 32 Kbyte serial interface

C823101 32 Kbyte parallel interface

C823151 Twinax interface board

C82314l Coax interface board

The Lower Paper Cassette Unit

Turn off the printer. Unplug the printer’s power cord from

the electrical outlet and from the printer.
Remove the optional face-up output tray, if installed.
Move the printer to one side. Then set the lower cassette

unit where your printer normally rests keeping the paper

cassette facing you.

4. Lift the printer and align over the cassette unit using the

two alignment pins on the lower cassette unit as guides.

Lower the printer so that the pins fit securely into the

holes on the bottom of the printer as shown below.

Note: The printer is heavy, so you may someone help
you lift it.

5. Reconnect the power cord to the printer and plug it into an

electrical outlet.

Turn on the printer.

The Face-up Output Tray

The printer normally delivers paper face down on top of the

printer. The optional face-up paper tray is recommended for

print jobs of twenty pages or less and when:

you feed single-sheet items such as envelopes

transparencies, heavy paper, or labels through your

printer.

you prefer your printed sheets feed from the printer with

the text facing you.

Installing the face-up output tray
1. Hold the output tray tilted at as light angle away from you.

Laser Printers

1/19/93 REV

AL1000/1500-3