Epson 1000 Reference Guide

8. Place the controller board on a clean, flat surface with the

bracket (connector) facing to your right.

The RAM chip sockets are located on the bottom left side of the

controller board.

The ActionLaser 1000 board has three vacant sectors and the

ActionLaser 1500 board has two vacant sectors, each containing

four chip sockets (identified by their IC numbers). Also notice

the notches on one end of each chip and socket. These notches

must be aligned for proper installation.

B

A

You can install the chip sets into any of the vacant sectors. See

the section “Selecting a memory chip set combination” earlier

in this chapter for a list of the RAM configurations possible for

the controller board.