Epson 1400 Reference Manual

5. The screen displays the default setup parameters that are designed to

be used for most computer environments. If the default parameters

are acceptable and you don’t need to make any changes, press Enter.

If you need to make changes, tab to

and press Enter. This brings

up a series of screens, each of which prompts you to change a setting.

For each setting, press Enter to accept the default or change the

setting and press Enter. The setup program begins uncompressing

files and copying them to your hard disk.

6. When a message appears telling you that installation was successful,

press Enter to exit the setup program.

This completes installation of the EPSON Control Panel for DOS.

To use your printer, select the HP LaserJet 4P printer driver in your

software program. If this driver is not available, contact your software

manufacturer for an updated version of the software program. Until you

receive the new version, you can use any LaserJet III driver or any driver

that uses HP PCL.
See your software manual for specific information on how to select a

printer driver.

Bringing up the EPSON Control Panel for DOS

To bring up the EPSON Control Panel for DOS, do the following:

1. At a C: prompt, change to the PANEL directory by typing

CD\PANEL. Then press Enter.

Note:

If you installed the EPSON Control Panel to a different directory than the

default, be sure to specify the correct pathname.

2. Type PANEL and press Enter.

Controlling Printer

Settings from MS-DOS

B-3