Epson PictureMate Quick Setup Guide
®
Start Here
Set up your PictureMate and
print –no computer required!
print –no computer required!
Note:
To print from your computer, see
Using PictureMate With a
Computer and your CD after completing these steps.
1
Unpack
PictureMate comes with all these items in the box.
Remove all the tape and packing material from PictureMate.
Caution:
To avoid damaging your PictureMate,
keep it out of the sun and don’t leave it in your
car or other location where it can get too hot.
car or other location where it can get too hot.
2
Install the Photo
Cartridge
Cartridge
1
Flip the handle up.
2
Open the cartridge door
on the back of PictureMate.
You see the release lever.
on the back of PictureMate.
You see the release lever.
3
Move the lever to the Release position by sliding it
in the direction shown.
in the direction shown.
4
Shake the photo cartridge
a few times in its package,
then unwrap the cartridge.
a few times in its package,
then unwrap the cartridge.
5
Slide the cartridge straight into the slot, label side up,
until it is fully inserted. Push in both sides evenly to
make sure it is not crooked.
until it is fully inserted. Push in both sides evenly to
make sure it is not crooked.
Caution:
Make sure both sides of the cartridge are even,
or ink may leak. If either side is sticking out, remove the
cartridge and reinstall it.
cartridge and reinstall it.
6
Move the lever right to the Lock position. If it does
not lock in place, the cartridge is not installed
correctly. Release it and try again.
not lock in place, the cartridge is not installed
correctly. Release it and try again.
7
Close the cartridge door. Make sure it snaps shut.
If the door does not close completely, the cartridge is
not installed correctly. Remove it and try again.
not installed correctly. Remove it and try again.
8
Flip the handle to the
back of PictureMate
and all the way down.
back of PictureMate
and all the way down.
3
Plug In and Turn
On PictureMate
On PictureMate
1
Connect the power cable
to the power adapter.
to the power adapter.
2
Plug the small cable into
the back of PictureMate.
the back of PictureMate.
3
Plug the other end of
the power cable into a
standard power outlet.
the power cable into a
standard power outlet.
4
Press the On button to turn on PictureMate.
PictureMate gets the ink ready for printing.
You see this message:
You see this message:
After a few minutes, when PictureMate is ready,
you see this message:
you see this message:
5
Press the OK button.
4
Load Paper
Your PictureMate comes with photo paper made especially
for it.
for it.
Caution:
Don’t load or print on plain paper; this may damage
PictureMate.
1
Flip open the
paper support.
paper support.
2
Pull up the paper
support all the way.
support all the way.
3
Open the output tray.
Note:
Make sure the paper support is fully extended.
PictureMate
Power cable
PictureMate Photo Cartridge
Paper
Using PictureMate
Without a Computer
booklet
Printer
Software
CD
+
Turn over
Using PictureMate
With a Computer
booklet
Power adapter
4051812-00 XXX
To release lever
Handle
Lever
Make sure the handle
is all the way down
Wrong
Right