Epson PM 240 Quick Setup Guide
2
Plug
1
Connect the power
PictureMate.
2
Connect the power
cable to the power
adapter.
cable to the power
adapter.
3
Plug the other end
of the power cable
into a power outlet.
of the power cable
into a power outlet.
4
Flip the handle to
5
Open the paper
6
Press the
On
After a moment, you
this on the photo
viewer screen:
this on the photo
viewer screen:
Now you can install your
3
Install
Photo
1
Open the cartridge
*410693400*
*410693400*
Start Here
Follow these steps to set up your PictureMate
®
Snap
or Flash and print–no computer required!
Note: PictureMate Snap is shown throughout, but the steps are the
same for PictureMate Flash. To print from your computer, see the
Basics book and your CD after completing these steps.
same for PictureMate Flash. To print from your computer, see the
Basics book and your CD after completing these steps.
1
Unpack
PictureMate comes with all these items in the box.
1
Remove all the tape and packing material from the
outside of PictureMate.
outside of PictureMate.
2
Open the cartridge door
on the back of
PictureMate.
on the back of
PictureMate.
3
Remove the packing
material from inside the
cartridge slot.
material from inside the
cartridge slot.
4
Close the cartridge door.
PictureMate
Initial PictureMate
photo cartridge
PictureMate
photo paper
Basics book
Printer Software CD
Power adapter
Power cable
®
PictureMate Snap
(PM 240)
PictureMate Flash
(PM 280)