Manualsbrain.com
  1. Manuals
  2. Brands
  3. Epson
  4. EMP-830
  5. Installation Instruction

Epson EMP-830 Installation Instruction

Download
Page of 20
16
1
2
Remove the cover when the projector has sufficiently cooled 
down. It takes about one hour after the power is turned off for the 
lamp to become sufficiently cool.
Replacing the Lamp
User's Guide "Replacing the Lamp"
Use the screwdriver that is supplied with the spare lamp or your own cross head screwdriver.
How to replace the lamp
Disconnect the 
power cable.
Remove the lamp 
cover at the side of 
the projector.
Loosen the lamp cover fixing screw.
Loosen the two lamp 
fixing screws.
Slide the lamp cover straight out, and then lift it up to 
remove it.
Hold the knob and 
pull out the old lamp.
1
2
3
A beep will sound and the Power indicator will switch to flashing green.
User's Guide "Turning the Projector On"
Projector Preparation and Adjustments
Connect the power 
cable to the 
projector and to an 
electrical outlet.
Press      .
When "Direct Power ON" is set 
to "ON", the power will turn on 
when the power cable is 
connected, without the need to 
press      .
User's Guide 
"List of Configuration Menu 
Commands"
Simple!
Place your fingers against the [    ] and [    ] on the lens cover 
and press in while pulling the lens cover forward to remove it.
To use the remote control, set the 
[R/C] switch to "ON".
Power indicator
Flashing green (warm-up in progress/approx. 30 seconds) 
→ Lit green
User's Guide "Preventing Theft (Password Protect)"
      will not work while warm-up is in progress.
If Password Protect has been enabled, the password entry 
screen will be displayed. Enter the password.
404401202   BK
2-B               Re
v.
2
404401202   DIC188
2-B                Re
v.
2