Glyph cy-misan-v User Guide
20
Setting Up the miSAN
Cybernetics
UM-MV-86-B1-0801
Series to a UPS. If you do not use a UPS, each power supply should be connected to a
separate power main.
separate power main.
Power Button
The miSAN-V-Series is powered on using the power button on the front panel (See Fig-
ure 2-2). Figure 2-2 shows the front view of a typical miSAN-V-Series.
ure 2-2). Figure 2-2 shows the front view of a typical miSAN-V-Series.
Both power supplies must be connected to an AC power source, preferably
separate power mains. The miSAN-V-Series uses both power suppl
simultaneously to provide immediate failover in case one power supply fails
separate power mains. The miSAN-V-Series uses both power suppl
simultaneously to provide immediate failover in case one power supply fails
If you use an APC® Smart-UPS® model UPS with a Network Managem
Card or a Tripp Lite® SmartPro®/SmartOnline™ model UPS with
SNMPWEBCARD, you can configure the UPS to send messages to the HS
when the power fails, enabling the HSTC to automatically shut itself do
cleanly.
Card or a Tripp Lite® SmartPro®/SmartOnline™ model UPS with
SNMPWEBCARD, you can configure the UPS to send messages to the HS
when the power fails, enabling the HSTC to automatically shut itself do
cleanly.
Figure 2-2 miSAN-V-Series Front Components
Power
Button
Hot Swap
SATA Disk Drive