Glyph cy-misan-v User Guide

tem is not set to use bi-directional authentication, these entries will not be checked
by the host system and will have no effect.

Since the miSAN-V-Series only maintains a single “iSCSI host username” and
“iSCSI host password,” all hosts that are intended to connect to the miSAN-V-
Series must use the same host username and password for CHAP authentication
with this miSAN-V-Series.

To set, change or remove the “iSCSI host username,” follow the same procedures
as for the “Menu password.”

This is the password that goes with the “iSCSI host username” above.

To set, change or remove the “iSCSI host password,” follow the same procedures
as for the “Menu password.”

Outgoing iSCSI Connections to Devices

You can configure the miSAN-V-Series to use up to four remote iSCSI target devices.
There are three submenu items for each numbered device: “Remote iSCSI device X,”
“Device X IP address” and “Device X iSCSI password.”

Choices are “Enabled” and “Disabled” for each remote iSCSI device.

Device X DNS Name or IP address

Set this to match the DNS Name or IP address of the remote iSCSI device (tape
drive, library, and/or iSCSI storage device (i.e. miSAN-D Series) with which the
miSAN-V-Series is to communicate.

Default is CyberneticsASP. This can be changed if necessary.

Device X iSCSI password

Set this to match the iSCSI Access Password of the remote iSCSI device with
which the miSAN-V-Series is to communicate.

Setup for using an external iSCSI device for 

additional Virtual Tape storage

The following steps show how to connect the miSAN-V Series to a iSCSI device for
additional Virtual Tape storage.

1. Select 

SCSI configuration > Outgoing iSCSI connections to devices from the

HSTC Options drop-down menu.