Glyph cy-misan-v User Guide
65
Operating the Web Control Panel
Cybernetics
UM-MV-86-B1-0801
bondX
Settings for “bondX IP address”, “bondX subnet mask” and “bondX MTU” will be
shown only if Bonding is set to
shown only if Bonding is set to
Enabled.
However, settings for the “eth” interfaces will be displayed only if “Bonding” is set
to
to
Disabled.
bondX IP address
The default “bond0 IP address” is
192.168.1.1. A static IP address is set with this
option.
bondX subnet mask
The default “bond0 subnet mask” is
255.255.255.0. This may be changed in the
same manner as for the “IP address”.
bondX MTU
This sets the Maximum Transmission Unit (MTU) size. Default value is
1500.
Choices are
1500 and 9000. The 9000 setting is for use only with Gigabit Ethernet
networks that are “jumbo” packet capable (See
Appendix C, “Glossary”
).
Message Delivery
The miSAN-V-Series can be configured to send email messages to notify selected
recipients when any of the following events occur:
recipients when any of the following events occur:
•
A copy from virtual to physical tape completes, which also reports whether the
copy was successful
copy was successful
•
A disk error occurs, which may require replacing the disk
•
The miSAN-V-Series goes offline unexpectedly due to a fatal error
To set up email messaging, the miSAN-V-Series must have access to a Simple Mail
Transfer Protocol (SMTP) server on the network.
Transfer Protocol (SMTP) server on the network.
Email messages sent by the miSAN-V-Series contain the following information fields:
Note
This menu item only appears when two or more Ethernet interfaces are
set to “Bonded”.
set to “Bonded”.
Note
This menu item only appears if the Ethernet interface supports Jumbo
frames. Otherwise, this item is hidden, and the MTU is set to 1500 by
default.
frames. Otherwise, this item is hidden, and the MTU is set to 1500 by
default.