Heartland 9730 User Guide
5
Mount clips here
(see page 6)
(see page 6)
Installation
Beginning installation
1.
Once the location of the unit has been determined construct an enclosure with dimensions as
shown on page 4. Be sure to take your time and measure accurately.
shown on page 4. Be sure to take your time and measure accurately.
2.
At this point you will have to create the opening for the power supply box. The power supply
box (included with the unit) must be mounted in the cupboard under the appliance opening. The
power supply box comes with 36" cable and can be mounted anywhere within the length of the
cable. At the rear of the opening and 16 1/4" from the left side, cut a slot 5 1/2" x 2 1/2" (see
illustration below). Ensure
power supply box comes with 36" cable and can be mounted anywhere within the length of the
cable. At the rear of the opening and 16 1/4" from the left side, cut a slot 5 1/2" x 2 1/2" (see
illustration below). Ensure
that you can easily slide the supply box through it. (The power
supply box is permanently attached to the appliance and is mounted after the appliance is
installed.)
installed.)
3.
Screw the anchor clips to the top of the cabinet opening as shown on page 6. These clips will
later secure the unit to the cabinet and must be installed. Find the centre of the opening and
mount the clips 7 3/16" on each side of the centre point, and extending from the opening
approximately 5/8".
later secure the unit to the cabinet and must be installed. Find the centre of the opening and
mount the clips 7 3/16" on each side of the centre point, and extending from the opening
approximately 5/8".