Eaton TPC2365/MTD User Manual

© 2008 Eaton Corporation. All Rights Reserved. All specifications are subject to change without notice.

•

19” x 1U (1.72”) x 7”

•

Approximate shipping weight: 9 lbs.

•

TPC2365-2980 and TPC2365-3732 
are 9.5” deep

•

Differential Mode - Line to Line

•

Common Mode - Line to Ground

•

Line to Line

•

Power inlet is on the rear panel  

•

Rated by UL/CSA at 125VAC/20A or    
250VAC/16A Rated by TUV at  

 

250VAC/16A

•

Three sections of (4) switched outlets on 
the rear panel.  Each group of four  

 

outlets are:
– Rated by UL/CSA up to 250VAC/15A
– Rated by VDE at 250VAC/10A

•

Local: Power “on or off” to the switched   
outlets

•

Off: When breaker is “on” but this switch 
is in the “off” mode, you will not have    
power to the outlets

•

Remote: Power “on or off” to the  

 

switched outlets via a remote device

•

Latching remote on “LT” models only,    
the selection switch is wired for  

 

Remote/Off/Remote - There is no local   
control

•

Remote on/off and EPO control - EPO    
overrides remote and local control

•

Sequence Power Up additional 
equipment down line (standard on all units

•

Latching remote “LT” models only -  

 

normally closed EPO, momentary start

•

Activated “Locally” or “Remotely”,  

 

Section 1 powers up, followed 
4-seconds later by Section 2 which is    
followed 4-seconds later Section 3
then 4-seconds later the sequenced  

 

remote activates the next system in line

•

Power to Section 1, 2 and 3

•

115 VAC or 230VAC input selected

•

Electromagnetic breaker provides manual 
on/off switching and trips in an overload 
condition

•

The AVS

TM

 system automatically senses 

the input voltage and adjusts the internal 
components to use that voltage for the output