Sony klv-23m1 User Guide

13

Installing the TV

When you unpack this unit, make sure it includes the
following:

• Do not detach the ferrite core from the cable.
• The ferrite core is attached to one end of (not the center of) the

cable. When connecting the cable to the TV, insert the end
with the ferrite core into the VHF/UHF jack.

Operating Instructions (1)

Quick Setup Guide (1)

Warranty Card (1)

AC power cord (1)

75-ohm coaxial cable (1)

Remote control (1) and
size AA batteries (2)

Insert two size AA batteries (supplied) by matching
the e and E on the batteries to the diagram inside
the remote control’s battery compartment.

• Remove the batteries to avoid damage from possible battery

leakage whenever you anticipate that the remote control will
not be used for an extended period.

• Handle the remote control with care. Avoid dropping it,

getting it wet, or placing it in direct sunlight, near a heater or
where the humidity is high.

• The supplied remote control can be programmed to operate most

video equipment (see “Programming the Remote Control” on
page 16).