Sony KLV-32M1 User Guide

23

Connecting and Setting the TV

It is strongly recommended to connect the antenna using a 75-
ohm coaxial cable to get optimum picture quality. A 300-ohm
twin lead cable can be easily affected by radio noise and the like,
resulting in signal deterioration. If you use a 300-ohm twin lead
cable, keep it away as far as possible from the TV.

Use this hookup if:

• You subscribe to a cable TV system that uses

scrambled or encoded signals requiring a cable
box to view all channels, and

• You do not intend to hook up any other audio or

video equipment to your TV.

Connect the coaxial connector from your cable
service to the cable box’s IN jack.

Using the supplied 75-ohm coaxial cable,
connect the cable box’s OUT jack to the TV’s
VHF/UHF jack.

Also, set “Cable” to “On” in the 

 (Channel)

menu (see page 38).

• The supplied remote control can be programmed to operate

your cable box (see “Programming the Remote Control” on
page 16).

• To change channels using the cable box, set your TV to

channel 3 or 4 depending on the cable box channel output.

• If you will be controlling all channel selection through your

cable box, consider using the Channel Fix feature to set your
TV to channel 3 or 4 (see page 39).

75-ohm coaxial
cable (supplied)

Rear of TV

VHF/UHF jack

You may find it necessary to use some of the
following connector types during set up.

Screw-on type

High quality video cable for enhanced picture quality

VIDEO - Yellow
AUDIO (Left) - White
AUDIO (Right) - Red

Some DVD players are equipped with the following
three video connectors:

Y - Green
P

B

 (C

B

, C

b

 or B-Y) - Blue

P

R

 (C

R

, C

r

 or R-Y) - Red

High definition multimedia interface cable

Rear of TV

VHF/UHF jack

IN
jack

OUT
jack

Cable

Cable box

75-ohm coaxial
cable (supplied)

Screw into connection.

Align guides and push into
connection.

Push into connection.

Push into connection.

Aligh guides and push into
connection.