Sony klv-s19a10 Operating Guide

KLV-S19A10/KLV-S23A10/KLV-S26A10/KLV-S32A10

2-589-826-13(1)

G:\SONY\03 TV\834494S KLV-S19-
32A10_EN\0601_EN\2589826131\2589826131 KLVS19-
32A10_US\01US04INS.fm

This scenario shows a SAT Box connected through the video inputs and the 
Cable/Antenna connected through the VHF/UHF input. Satellite signals are 
selected by the SAT Box through the video inputs while TV signal is 
selected by the TV tuner.

Connect the satellite antenna cable to the satellite receiver’s satellite 
input jack.

Use an A/V and S VIDEO cables to connect the satellite receiver’s 
AUDIO and S VIDEO output jacks to the TV’s AUDIO and S VIDEO 
input jacks (VIDEO 1 or 3).

Connect the supplied 75-ohm coaxial cable from the antenna to the 
TV’s VHF/UHF input jack.

Run the Initial Setup program, as described in “Setting Up the Channel 
List” on page 30.

If your satellite receiver is not equipped with S VIDEO, use a 
VIDEO cable (yellow) instead of the S VIDEO cable.

z

If you connect the Digital 
Satellite Receiver with 
component video cables, 
see page 20.

Rear of TV

A/V cable

Satellite Receiver

75-ohm coaxial 
cable

Satellite 
antenna 
cable

S VIDEO cable

S VIDEO

VIDEO 
(yellow)

AUDIO-L 
(white)
AUDIO-R 
(red)

Watch the satellite receiver

Press 

WEGA GATE

 to select the Satellite input (Video 1, 2 or 3) in 

the External Inputs list.

or

Press 

TV/VIDEO

 repeatedly to select the satellite receiver input 

(Video 1, 2 or 3).

Set up the remote control to operate the satellite 
receiver

You must program the remote control. See “Programming the 
Remote Control” on page 34.

Activate the remote control to operate the 
satellite receiver

Press 

SAT/CABLE (FUNCTION)

.

Control satellite receiver functions with the 
remote control

See “Operating a Satellite Receiver” on page 36.

Label video inputs to easily identify equipment 
connected to the TV

See the instructions for setting up 

Label Video Inputs

01US02WAR-UC.book  Page 19  Wednesday, June 1, 2005  4:07 PM