Soundstream pcx2.180 User Guide
8
CO
N
TR
O
LS
&
F
UN
CT
IO
N
S
Controls & Functions
10. B+ Terminal (Battery positive)
Due to the power requirements of the Amplifier, this connection should be made
directly to the positive(+) terminal of battery. For safety measure, install an in-line
fuse Holder (not included) as close to the battery positive(+) terminal as possible with
an ampere rating ; not to exceed total value of fuses in Amp.
directly to the positive(+) terminal of battery. For safety measure, install an in-line
fuse Holder (not included) as close to the battery positive(+) terminal as possible with
an ampere rating ; not to exceed total value of fuses in Amp.
9. LED Indicator
PWR(Power): This GREEN LED will illuminate when the amplifier is turned "ON".
If it fails to illuminate, check the power connections to the Amplifier and fuses.
If it fails to illuminate, check the power connections to the Amplifier and fuses.
PROT(Protection): The amplifier protection circuitry will disable the amplifier if input overload,
short circuit or extremely high temperature conditions are detected. When the protection
mode is in operation, the LED indicator on the side panel will be illuminated, indicating the
amplifier has gone into a self-preservation mode.
short circuit or extremely high temperature conditions are detected. When the protection
mode is in operation, the LED indicator on the side panel will be illuminated, indicating the
amplifier has gone into a self-preservation mode.
If you observe that the Protection LED is lit, please check the system carefully to determine
what has caused the protection circuit to engage. The amplifier can be reset by turning the
remote power off and then on again. If the amplifier shut down due to a thermal overload
condition, please allow it to cool down before restarting. If the amplifier shut down because
of an input overload or short circuit, be sure to repair these conditions before attempting to
power up the amplifier again.
what has caused the protection circuit to engage. The amplifier can be reset by turning the
remote power off and then on again. If the amplifier shut down due to a thermal overload
condition, please allow it to cool down before restarting. If the amplifier shut down because
of an input overload or short circuit, be sure to repair these conditions before attempting to
power up the amplifier again.
11. Remote Power On
PWR
PROT
POWER
BATT
REM
GND
POWER
BATT
REM
GND
PCX5.600
PCX4.240 / 4.360 / 4.540
PCX2.180/2.270/2.350/2.440/
PCX2.540/2.700
PCX2.540/2.700
POWER
BATT
REM
GND
POWER
BATT
REM
GND
PCX5.600
PCX4.240 / 4.360 / 4.540
PCX2.180/2.270/2.350/2.440/
PCX2.540/2.700
PCX2.540/2.700