Bushnell 10-1907 Instruction Manual
4
3
A QUICK START LESSON
1. Turn the Speedster "ON" by pressing the POWER button.
2. The following introduction screen will appear for 2-3 seconds.
2. The following introduction screen will appear for 2-3 seconds.
3. After the above introduction screen has appeared for 2-3 seconds, the Speedster will automatically
proceed to the following SPEED screen.
4. Aim the Speedster at the target and depress the TRIGGER. As a quick reference to accuracy,
remember to keep your targets direction of travel in a direct line with you, and not perpendicular
to you.
to you.
Your Bushnell Speedster can be configured for several different modes of operation. These are
described in the following "GETTING STARTED" section.
described in the following "GETTING STARTED" section.
NOTE: The Speedster contains an automatic battery saving shut-off feature. After 30 minutes of
non-use, the Bushnell Speedster will automatically shut off.
non-use, the Bushnell Speedster will automatically shut off.
The Speedster automatically saves data for later use to internal memory while in the "SPEED +
BASEBALL STATS" Mode. Data captured in the "SPEED" only mode can not be saved to internal
memory.
BASEBALL STATS" Mode. Data captured in the "SPEED" only mode can not be saved to internal
memory.
The Speedster comes with a padded carrying case and adjustable strap that can be used as a hand-
strap or neck-strap. Simply thread the strap through the lanyard pin located at the bottom of the
handle.
strap or neck-strap. Simply thread the strap through the lanyard pin located at the bottom of the
handle.
GETTING STARTED
To turn the Speedster "ON" simply press the "POWER" button. Once you have done so, you will
see the following introduction screen for approximately 2-3 seconds (Figure 2)
see the following introduction screen for approximately 2-3 seconds (Figure 2)
After the above introduction screen has appeared for 2-3 seconds, it will automatically take you to the
following "SPEED" screen (Figure 5).
following "SPEED" screen (Figure 5).
SPEED SCREEN
At this point, you are ready to capture speed. However, if you desire to track baseball statistics as well
as speed, press the PAGE button to advance to the SETUP screen (Figure 3).
as speed, press the PAGE button to advance to the SETUP screen (Figure 3).
SETUP Screen
SETUP SCREEN DEFINITIONS
SESSION
Resume: Continues average and last speed display and calculations, and all player statistics
(Pitches, Balls, Strikes) from previous sessions (SPEED + BASEBALL STATS Mode only)
Clear Memory: Clears (erases) all stored players’ information, and average and last speed
memory, display and calculations
(Pitches, Balls, Strikes) from previous sessions (SPEED + BASEBALL STATS Mode only)
Clear Memory: Clears (erases) all stored players’ information, and average and last speed
memory, display and calculations
MODE
Speed + Baseball Stats: Allows the user to record speed and enter Baseball Statistics for up
to eight separate pitchers. Provides current, last, and average speed, total pitch, strike, and
ball count.
Speed Only: Allows the user to capture current, last, and average speed.
to eight separate pitchers. Provides current, last, and average speed, total pitch, strike, and
ball count.
Speed Only: Allows the user to capture current, last, and average speed.
UNITS
MPH: Speed will be displayed in Miles Per Hour
KPH: Speed will be displayed in Kilometers Per Hour
KPH: Speed will be displayed in Kilometers Per Hour
(NOTE: Average Speed = Sum of all recorded speeds / Number of recorded speeds)
(Figure 5)
(Figure 2)
(Figure 3)
SPEED (MPH)
53
Last: 57
AVG: 55
SPEED (MPH)
53
Last: 57
AVG: 55
SETUP
Session:
Resume
Mode:
Speed
Units:
MPH