LG 32LF561V User Guide

13

(Only satellite models)
Connect the TV to a satellite dish to a satellite socket with a satellite RF 
cable (75 Ω).

(Only UF67**)

- On : Support 4K @ 50/60 Hz (4:4:4, 4:2:2, 4:2:0)

- Off : Support 4K @ 50/60 Hz (4:2:0)

•  All HDMI ports support the HDCP 2.2. 
•  4K Source is only supported in HDMI input.
•  4K signal and content are not available in the RF/USB input.
•  All HDMI input ports support 4K @ 50/60 Hz (For details on the 

supported specifications, refer to the table below.) for high-
definition video. Picture or sound may not be supported depending 
on the specifications of the external device connected. In that case, 
change the settings for HDMI ULTRA HD Deep Colour.

3840 x 2160p
4096 x 2160p

50.00
59.94
60.00

YCbCr 4:2:0

YCbCr 4:2:0

YCbCr 4:2:2

YCbCr 4:4:4

-

-

RGB 4:4:4

-

-

(Depending on model)
View the encrypted (pay) services in digital TV mode. 

•  Check if the CI module is inserted into the PCMCIA card slot in the 

right direction. If the module is not inserted properly, this can 
cause damage to the TV and the PCMCIA card slot.

•  If the TV does not display any video and audio when CI+ CAM is 

connected, please contact to the Terrestrial/Cable/Satellite Service 
Operator.

(Depending on model)
Transmits the video and audio signals from an external device to the 
TV set. Connect the external device and the TV set with the euro scart 
cable.

(TV Out

1

)

Digital TV

Digital TV

Analogue TV, AV

Analogue TV

Component
HDMI

1  TV Out : Outputs Analogue TV or Digital TV signals.

•  Any Euro scart cable used must be signal shielded.
•  When watching digital TV in 3D imaging mode, only 2D out signals 

can be output through the SCART cable. (Only 3D models)

Connect your TV to external devices. For the best picture and audio 
quality, connect the external device and the TV with the HDMI cable. 
Some separate cable is not provided.

(Depending on model)
The descriptions in this manual are based on the buttons on the remote 
control. Please read this manual carefully and use the TV correctly.
To replace batteries, open the battery cover, replace batteries (1.5 
V AAA) matching the   and   ends to the label inside the 
compartment, and close the battery cover. To remove the batteries, 
perform the installation actions in reverse.

•  Do not mix old and new batteries, as this may damage the remote 

control.

•  The remote control will not be included for all sales market.

Make sure to point the remote control toward the remote control sensor 
on the TV.