Chief KCD220B User Manual

Model: K-Series

Installation Instructions

8.

Using 5/32" hex key, install screw (110) and nut (120)
on each end of the array (10) to prevent displays from
accidently sliding off (See Figure 17).

9.

Proceed to "CABLE MANAGEMENT."

1.

Verify that you have the following parts:

2.

Insert pin (60) into Y-connector upper bore in mount
(20) (See Figure 18).

3.

Install spacer (70) or washer (80), as desired, on pin
(60) (See Figure 18).

NOTE: Spacer (70) will allow limited movement of arm

assembly (10) relative to Y-connector, dependent
upon tension of screw (30).  Washer (80) will lock
arm assembly (10) to Y-connector.  See
"ADJUSTMENT" for detail.

4.

Insert arm assembly (10) on pin (60) (See Figure 18).

5.

While holding nut (90) in lower bore of Y-connector,
insert screw (30) through washer (50), washer (40),
washer (50), arm assembly (10), and Y-connector,
into nut (90) (See Figure 18).  Loosely install screw
(30) using 3/16" hex key.

CAUTION: Improper positioning of arm assembly (10)
may result in failure of mount and subsequent damage
to displays.  Do NOT position either arm assembly (10)
in gray shaded area.

6.

Position arm assembly (10) within UNSHADED area
as shown (See Figure 19).  Using 3/16" hex key,
tighten screw (30) as required to maintain position.

10

ARM ASSEMBLY, K-Series

2

20

MOUNT, Desk, K-Series

1

30

SCREW, Button Head Cap, 5/16"-18 x 4"

2

40

WASHER, 5/16", UHMW (plastic)

2

50

WASHER, 5/16", Stainless Steel

4

60

PIN

2

70

SPACER, UHMW (plastic)

2

80

WASHER, Lock, External Tooth, 5/8"

4

90

NUT, Nylok, 5/16"-18

2

110

120

NOTE: Left side shown; right side similar

10

30

50

40

50

80 or

70

60

Y-connector

20

NOTE: KCY-220
shown; KCY-210
similar.

NOTE: All parts
same for both sides.

90