Chief KCD220B User Manual
Model: K-Series
Installation Instructions
2
IMPORTANT WARNINGS AND CAUTIONS!
WARNING: A WARNING alerts you to the possibility of serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of damage or destruction of equipment if you do not follow the
corresponding instructions.
corresponding instructions.
WARNING: Failure to provide adequate structural strength for this component can result in serious personal injury
or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is
attached can support five times the combined weight of all equipment. Reinforce the structure as required before
installing the component.
or damage to equipment! It is the installer’s responsibility to make sure the structure to which this component is
attached can support five times the combined weight of all equipment. Reinforce the structure as required before
installing the component.
WARNING: Exceeding the weight capacity can result in serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of all components does not exceed the maximum support
weight as stated in the Specifications section.
installer’s responsibility to make sure the combined weight of all components does not exceed the maximum support
weight as stated in the Specifications section.
WARNING: Allowing any part of your body or component cables to be caught between movable parts can result in
serious personal injury or damage to equipment!
serious personal injury or damage to equipment!
CAUTION: Overtightening fasteners may result in improper operation, excessive wear or damage to equipment,
and/or voiding of factory warranty!
and/or voiding of factory warranty!
CONTENTS
TOOLS REQUIRED FOR INSTALLATION ............................................................................................................... 2
SPECIFICATIONS .....................................................................................................................................................3
MOUNT INSTALLATION ........................................................................................................................................... 4
DISPLAY INSTALLATION .........................................................................................................................................7
ARRAY ASSEMBLY (DUAL / TRIPLE DISPLAY; ALL EXCEPT KCY-210/-220)....................................................... 9
MULTI-DUAL ARM ASSEMBLY (KCY-210/-220 ONLY)..........................................................................................10
CABLE MANAGEMENT .......................................................................................................................................... 11
ADJUSTMENT ........................................................................................................................................................ 12
TOOLS REQUIRED FOR INSTALLATION
•
Phillips Screwdriver, #1 and #2
•
9/16" Wrench (KSA-1015/-1016 Only)
•
Drill (All Wall Mounts)
•
1/8" Drill Bit (All Wall Mounts except KSA-1015/-1016)
•
1/4" Drill Bit (KSA-1015/-1016 Only)
•
2.5mm Hex Key (approximately 3/32"; provided with Desk Mounts)
•
5/32" Hex Key (provided with applicable K-Series mounts)
•
3/16" Hex Key (provided with all K-Series mounts)
NOTE: Other tools may be required depending on your method of installation.