LG SH5 User Manual

Connecting

Connecting

Manually pairing wireless subwoofer

When your connection is not completed, you can
check red LED or blinking green LED on the wireless
subwoofer and the wireless subwoofer does not
make sound. To solve the problem, follow the steps
below.
1. Adjust volume level of the main unit to minimum.

- ”MIN” appears on the display window.

2. Press and hold

(Mute) on the remote control

for about 3 seconds.

- “SUB-WF RESET” appears on the display

window.

3. Press and hold

Pairing on the back of the wireless

subwoofer for more than 5 seconds.

- The LED of the wireless subwoofer lights up

alternately in red and yellow-green.

4. Disconnect the power cord of the main unit and

the wireless subwoofer.

5. Connect them again after the LED of the main

unit and the wireless subwoofer is fully turned
off.

The main unit and the wireless subwoofer will be
paired automatically when you turn on the main
unit.

- Turn on the main unit : The sound bar and

wireless subwoofer will be

automatically

connected.

- Green LED on the rear of wireless subwoofer

turns on.

y It takes a few seconds (and may take longer)

for the main unit and the subwoofer to
communicate with each other and make
sounds.

y The closer the main unit and the subwoofer,

the better sound quality. It is recommended
to install the main unit and the subwoofer as
close as possible and avoid the cases below.

- There is a obstacle between the main unit

and the subwoofer.

- There is a device using same frequency

with this wireless connection such as
a medical equipment, a microwave or a
wireless LAN device.

Note