LG LDG5315ST User Guide

16 INSTALLATION

Anti-tip 

bracket

Wall plate

Screw must 

enter wood or 

concrete

The anti-tip bracket is packaged with an installation 

template. The instructions include necessary 

information to complete the installation. Read and 

follow the range installation instruction sheet.

 

•

Range must be secured with an approved  

anti-tip device.

 

•

The range could be tipped by standing, sitting 

or leaning on an open door if the range or  

anti-tip device is not properly installed.

 

•

After installing the anti-tip device, verify that it is 

in place by carefully attempting to tilt the range 

forward.

 

•

This range has been designed to meet all 

recognized industry tip standards for all normal 

conditions.

 

•

The installation of the anti-tip device must meet 

all local codes for securing the appliance.

 

•

The use of this device does not preclude tipping 

of the range when not properly installed.

Your range is designed to operate at a pressure of 

5" of water column on natural gas or 10" of water 

column on LP.
Make sure you are supplying your range with the type 

of gas for which it is configured.
This range is convertible for use on natural or LP gas. 

When using this range on LP gas, conversion must 

be made by a qualified LP installer before attempting 

to operate the range.
For proper operation, the pressure of natural gas 

supplied to the regulator must be between 5" and 13" 

of water column.  
For LP gas, the pressure supplied to the regulator 

must be between 10" and 13" of water column. When 

checking for correct operation of the regulator, the 

inlet pressure must be at least 1" more than the 

operating (manifold) pressure as given above.
The pressure regulator located at the inlet of the 

range must remain in the supply line regardless of 

which type of gas is being used.
A flexible metal appliance connector used to connect 

the range to the gas supply line should have an I.D. 

of 

5

/

8

" and a maximum length of 5 feet. In Canada, 

flexible connectors must be single wall metal 

connectors less than 6 feet in length.